ICON Series power amplifiers are designed with the needs of sound contractors in mind. The binding post outputs allow for connection to standard low impedance speakers. Barrier strip outputs enable 25V, 70V and 100V Line operation. Each amplifier channel has a separate toroidal secondary transformer that provides full electrical isolation and ensures maximum audio separation. Features like power up muting, full short-circuit, temperature, DC offset protection and a built-in 45 Hz subsonic filter, combine to make the Icon Series an attractive, cost effective solution for any audio installation.
Direct Power Out
Max. average power at 45Hz-20kHz. With 0.1% THD
- 8 ohm - 240W× 2
- 4 ohm - 400W× 2
- 2 ohm, 1kHz,1%THD - 550W× 2
Bridged mono 8 ohm, 1kHz,1%THD - 850W
Bridged mono 4 ohm, 1kHz,1%THD - 1100W
Isolated Constant Voltage Out
- 200V or 140V Bridge 700W
- 100V or 70V 350W×2
- 25V 280W×2
Frequency Response
Direct Outputs (+0/-2dB) 50Hz-50kHz
Isolated Outputs (+0/-2dB) 50Hz-16kHz
Total Harmonic Distortion 0.05 0.05
Sensitivity (for full output) -1.02V
Voltage Gain - 32dB
Input Impedance
Balanced/Unbalanced 20k/10k ohm
Damping Factor >200 (direct output)
S/N Ratio Less than 100dB below rated output (20Hz-20kHz)
Protection Circuits - Output offset voltage protection, heat sink overheat protection, Transformer overheat protection, Load shorting protection, Power on/off protection
Controls
Front Panel - Power Switch
Rear Panel Ch1 & Ch2 gain controls (41 click); Parallel/Stereo/Bridge switch
Connectors
Input; XLR jack ×2,Barrier strip ×1
Output; Covered Barrier strip ×2;heavy-duty binding post
Cooling; One dual speed fan
Indicators
Limit: Red Signal: Green
Protect: Yellow Power: Red
Dimensions (W×H×D)
480 x 132 x 428 mm
Net Weight
24.7 Kg (54.6 lbs)
You may also like:
For export (= shipments outside of Singapore) we do not charge GST. In this case, please refer to the prices excl GST.
